 |
| Home › FAQ › Bike Racks |
|
| |
The WRTA bike racks hold two bikes at a time. There is no extra charge for taking your bike — just pay the regular fare! Riders are responsible for loading and securing their bikes and unloading them from the racks.
|
| How To Use the Rack |
|
| 1. |
For your safety, load and unload from the front and curb side only. Traffic will be passing the bus on the driver's side.
|
| 2. |
Lower the rack with one hand while holding your bike.
|
| 3. |
Once the rack is lowered, lift the bike into either set of the rack's wheel holders.
|
| 4. |
Pull the arm out and up over the front tire of the bike. The only point of contact between the bike and the bike rack is on the rubber tires, eliminating any possible damage.
|
| 5. |
Once the bike is loaded, you're ready to board the bus.
|
| 6. |
Remember to unload your bike when you leave the bus! To unload, release the arm by lifting up and over, and then lower the arm.
|
| 7. |
Then, lift the bike carefully out of the wheel holders.
|
| 8. |
If no other bikes are on the rack, return the rack to the folded position.
|
|
| back to top |
